Extcall - Siemens SINUMERIK 840D sl Operating Manual

Managing programs

12.14 EXTCALL

12.14 EXTCALL
The EXTCALL command can be used to access files on a local drive, USB data carriers or
network drives from a part program.
The programmer can set the source directory with the setting data SD $SC42700
EXT_PROG_PATH and then specify the file name of the subprogram to be loaded with the
EXTCALL command.
Supplementary conditions
The following supplementary conditions must be taken into account with EXTCALL calls:
● You can only call files with the MPF or SPF extension via EXTCALL from a network drive.
● The files and paths must comply with the NCK naming conventions (max. 25 characters
● A program is found on a network drive with the EXTCALL command if
● For programs that were generated on external storage media (Windows system) observe
604
Press the "Rotate right" softkey to rotate the document through 90
degrees to the right.
7. Press the "Back" softkey to return to the previous window.
8. Press the "Close" softkey to exit the PDF display.
for the name, 3 characters for the identifier).
– with SD $SC42700 EXT_PROG_PATH the search path refers to the network drive or
a directory contained on the network drive. The program must be stored directly on
that level, no subdirectories are searched.
– without SD $SC42700 the correct location of the program is specified in the EXTCALL
call itself by means of a fully qualified path that can also point to a subdirectory of the
network drive.
upper- and lower-case syntax.
Note
Maximum path length for EXTCALL
The path length must not exceed 112 characters. The path comprises the contents of the
setting data (SD $SC42700) and the path data for EXTCALL call from the part program.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling