Programming technological functions (cycles)
8.4 Turning - only for G code programs
8.4
Turning - only for G code programs
8.4.1
General
In all turning cycles apart from contour turning (CYCLE95), in the combined roughing and
finishing mode, when finishing it is possible to reduce the feedrate as a percentage.
8.4.2
Stock removal (CYCLE951)
8.4.2.1
Function
Function
You can use the "Stock removal" cycle for longitudinal or transverse stock removal of
corners at outer or inner contours.
Note
Removing stock from corners
For this cycle, the safety clearance is additionally limited using setting data. The lower value
is taken for machining.
Please refer to the machine manufacturer's specifications.
412
Machine manufacturer
Please also refer to the machine manufacturer's specifications.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling