Parameters, G code program
PL
Machining plane
RP
Retraction plane
SC
Safety clearance
Parameter
Description
Machining
Single position
•
position
Drill hole at programmed position.
(only for G
Position pattern
•
code)
Position with MCALL
Z0 (only for G
Reference point Z
code)
Machining
Stock removal
•
The drill is retracted from the workpiece for stock removal.
Chipbreaking
•
The drill is retracted by the retraction distance V2 for chipbreaking.
Drilling depth
Shank (drilling depth in relation to the shank)
•
The drill is inserted into the workpiece until the drill shank reaches the value
programmed for Z1. The angle entered in the tool list is taken into account.
Tip (drilling depth in relation to the tip)
•
The drill is inserted into the workpiece until the drill tip reaches the value
programmed for Z1.
Z1
Drilling depth (abs) or drilling depth in relation to Z0 (inc)
It is inserted into the workpiece until it reaches Z1.
D - (only for G
1. Drilling depth (abs) or 1st drilling depth in relation to Z0 (inc)
code)
D - (only for
Maximum depth infeed
ShopMill)
FD1
Percentage for the feedrate for the first infeed
DF
Infeed:
Amount for each additional infeed
•
Percentage for each additional infeed
•
DF = 100%: Infeed increment remains constant
DF < 100%: Infeed increment is reduced in direction of final drilling depth.
Example: Last infeed was 4 mm; DF is 80%
next infeed = 4 x 80% = 3.2 mm
next infeed = 3.2 x 80% = 2.56 mm etc.
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Parameters, ShopMill program
T
mm
D
mm
F
S / V
Programming technological functions (cycles)
Tool name
Cutting edge number
Feedrate
Spindle speed or constant cutting
rate
8.1 Drilling
mm/min
mm/rev
rpm
m/min
Unit
mm
mm
mm
mm
%
mm
%
307