Parameter
Description
only for align cut segmentation at the edge:
Constant cutting depth
alternating cutting depth
Allowance
Allowance for pre-finishing - (only for ∇∇∇)
•
•
U1
Compensation allowance in X and Z direction (inc) – (only for allowance)
•
•
Set machining area
Set machining area limits
limits
•
•
with limited machining area only, yes:
XA
XB
ZA
ZB
Relief cuts
Machine relief cuts
•
•
FR
Insertion feedrate, relief cuts
* Unit of feedrate as programmed before the cycle call
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Yes
U1 contour allowance
No
Positive value: Compensation allowance is kept
Negative value: Compensation allowance is removed in addition to finishing
allowance
Yes
No
1. Limit XA ∅
2. Limit XB ∅ (abs) or 2nd limit referred to XA (inc)
1. Limit ZA
2. Limit ZB (abs) or 2nd limit referred to ZA (inc)
Yes
No
Programming technological functions (cycles)
8.5 Contour turning- only for G code programs
Unit
s
mm
mm
*
463