Graphic Display - Siemens SINUMERIK 840D sl Operating Manual

Tool management

11.9 Graphic display

11.9 Graphic display
In addition to the list of tools, you can also display the tools and magazine locations in a
dynamic graphic display.
The tools are displayed in the list in the order with their correct proportions.
The graphic display must be set up by the machine manufacturer.
References
For additional information, please refer to the following documentation:
Commissioning Manual SINUMERIK Operate (IM9) / SINUMERIK 840D sl
Graphic display of tools and magazine locations
Figure 11-18 Graphic display of tools and magazine locations
The following applies to the graphic display:
● If a tool is too long for the display, the maximum possible length is shown.
● Oversized tools are trimmed on the left and right sides.
558
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling