System integration
5.2 Navigating the Modbus display menu
5.2
Navigating the Modbus display menu
1. Power up the device. If the device has been installed correctly a new menu entry has
appeared in the local user interface of the device (between the "Reset mode" and the "Service
mode" menu entries.)
2. Navigate the new menu:
– Press
– Press
– Press
– Cycle through the MODBUS RTU settings by pressing
20
for two seconds. The display now says "Basic settings"
until you reach the "MODBUS RTU module" menu entry
Figure 5-1
MODBUS USMII Display menu
.
Operating Instructions, 03/2021, A5E00753974-AB
Modbus RTU RS 485