Module-Specific Information At The Device Display; Block 5: Status Of The Event List Via Profibus Dp; Block 5: Redundancy Status And Toggle Bit Timer - Siemens SIPROTEC Manual

Redundant PROFIBUS DP interface
1.5

Module-specific information at the device display

Module B
Module D
1.5.1

Block 5: Status of the event list via PROFIBUS DP

EvEntr
1.5.2

Block 5: Redundancy status and Toggle bit timer

28
The display of module-specific information is accessible with the following menu items
or buttons:
• MENU
• Test/Diagnose → 5
• Modulinfos → 5
• Port B → 1
• MENU
• Test/Diagnose → 5
• Modulinfos → 5
• Port D → 3
General module-specific information blocks are described in the manual "SIPROTEC
Communication module, PROFIBUS DP - Communication profile", chap. "Display of
module-specific information at the SIPROTEC device".
In addition to the number of event list entries, the status "Message lost" (ref. to chap.
1.4.1.1) is shown in this line, e.g.:
EvEntr: 12/3, ELost
In addition to the module information blocks 1 to 5, a new block 6 is available for each
module in a device with redundant PROFIBUS DP to show redundancy status and
Toggle bit timer information.
RedSta: PRIMARY
RedMSt: PRIMARY
RedDia: 2Ah, 29h
RedCoT: Chk.req
RedCoR: Chk.cnf
RedTrc: 0.30s,0
RedTsp: 2s,46
Ttoggl: 3.0s,0
Figure 1-10 Module-specific information - Redundancy status and Toggle bit timer
Block 6:
Redundancy status and Toggle bit timer
Block 6 is available only for devices with redundant
PROFIBUS DP slave.
56
56
N
R
R
SIPROTEC PROFIBUS DP - Bus mapping 6MD662/3/4
C53000-L1840-B011-03