Configuring Mac Addresses For A Do1X Profile - Dell Z9500 Configuration Manual

dot1x critical-vlan [{vlan-id}]
Specify a VLAN interface identifier to be configured as a critical VLAN. The VLAN ID range is 1– 4094.
Example of Configuring a Critical VLAN for an Interface
Dell(conf-if-Te-2/1)#dot1x critical-vlan 300
Dell(conf-if-Te 2/1)#show config
!
interface TenGigabitEthernet 2/1
switchport
dot1x critical-vlan 300
no shutdown
Dell#show dot1x interface tengigabitethernet 2/1
802.1x information on Te 2/1:
------------------------------------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Critical VLAN
Critical VLAN id:
Re-Authentication:
Untagged VLAN id:
Guest VLAN:
Guest VLAN id:
Auth-Fail VLAN:
Auth-Fail VLAN id:
Auth-Fail Max-Attempts:
Mac-Auth-Bypass:
Mac-Auth-Bypass Only:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Host Mode:
Auth PAE State:
Backend State:

Configuring MAC addresses for a do1x Profile

To configure a list of MAC addresses for a dot1x profile, use the mac command. You can configure 1 to 6 MAC addresses.
• Configure a list of MAC addresses for a dot1x profile.
DOT1X PROFILE CONFIG (conf-dot1x-profile)
mac mac-address
mac-address — Enter the keyword mac and type up to the 48– bit MAC addresses using the nn:nn:nn:nn:nn:nn format. A
maximum of 6 MAC addresses are allowed.
Example of Configuring a List of MAC Addresses for a dot1x Profile
The following example configures 2 MAC addresses and then displays these addresses.
Dell(conf-dot1x-profile)#mac 00:50:56:AA:01:10 00:50:56:AA:01:11
Dell(conf-dot1x-profile)#show config
dot1x profile sample
mac 00:50:56:aa:01:10
mac 00:50:56:aa:01:11
Dell(conf-dot1x-profile)#
Enable
AUTO
AUTHORIZD(MAC-AUTH-BYPASS)
Enable
300
Disable
400
Enable
100
Disable
NONE
NONE
Enable
Enable
3 seconds
60 seconds
2
30 seconds
30 seconds
3600 seconds
2
SINGLE_HOST
Authenticated
Idle
802.1X 86