Connecting And Configuring A J-Ex Series Switch (Cli Procedure) - Dell PowerConnect J-EX8216 Hardware Manual

Dell PowerConnect J-Series J-EX8216 Ethernet Switch Hardware Guide
Related
Documentation

Connecting and Configuring a J-EX Series Switch (CLI Procedure)

144
reset-chassis-lcd-menu;
}
}
}
protocols {
igmp-snooping {
vlan all;
}
lldp {
interface all;
}
rstp;
}
ethernet-switching-options {
storm-control {
interface all;
}
}
Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 144
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 146
For information about J-EX Series switch configuration files and interfaces and
instructions for reverting to the factory default configuration, see the Dell PowerConnect
J-Series Ethernet Switch Complete Software Guide for Junos OS at
http://www.support.dell.com/manuals
J-EX8216 Switch Hardware Overview on page 3
There are two ways to connect and configure a J-EX Series switch: one method is through
the console using the CLI and the other is using the J-Web interface. This topic describes
the CLI procedure.
NOTE: To run the
configuration as the active configuration. If you have configured anything on
the switch and want to run
See Reverting to the Default Factory Configuration for the J-EX Series Switch.
Before you begin connecting and configuring a J-EX Series switch through the console
using the CLI:
Set the following parameter values in the console server or PC:
Baud Rate—9600
Flow Control—None
Data—8
Parity—None
.
script, the switch must have the factory default
ezsetup
ezsetup , revert to the factory default configuration.