Connecting And Configuring A J-Ex Series Switch (Cli Procedure) - Dell PowerConnect J-EX4200 Hardware Manual

Related
Documentation

Connecting and Configuring a J-EX Series Switch (CLI Procedure)

}
ethernet-switching-options {
storm-control {
interface all;
}
}
poe {
interface all;
}
Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 131
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 133
For information about J-EX Series switch configuration files and interfaces and
instructions for reverting to the factory default configuration, see the Dell PowerConnect
J-Series Ethernet Switch Complete Software Guide for Junos OS at
http://www.support.dell.com/manuals
There are two ways to connect and configure a J-EX Series switch: one method is through
the console using the CLI and the other is using the J-Web interface. This topic describes
the CLI procedure.
NOTE: To run the
configuration as the active configuration. If you have configured anything on
the switch and want to run
For instructions, see the Dell PowerConnect J-Series Ethernet Switch Complete
Software Guide for Junos OS at
Before you begin connecting and configuring a J-EX Series switch through the console
using the CLI:
Set the following parameter values in the console server or PC:
Baud Rate—9600
Flow Control—None
Data—8
Parity—None
Chapter 12: Performing Initial Configuration
.
ezsetup script, the switch must have the factory default
, revert to the factory default configuration.
ezsetup
http://www.support.dell.com/manuals
.
131