Loading Model And Support Cartridges - Stratasys J3 Series User Manual

Stratasys J3 Series User Guide

Loading Model and Support Cartridges

The number of materials loaded in J3 Series printers depends on the active
printing mode. Each cartridge contains 1.1 kilograms of material when full.
• In High Quality Speed mode, you print with 3 different model material
• In Long Print mode, you can print with 1 or 2 cartridges of the same model
DOC-19001 Rev. G
cartridges and 1 cartridge of support material.
Figure 4-5 Material cabinet setup for High Quality Speed mode
material and 1 or 2 cartridges support. In this mode, there are 3 material
loading options:
Option 1:
M1 and M2 channels are loaded with the same model material and M3/S
and S channels are loaded with support.
Figure 4-6 Single material in M1 and M2, support in M3 and S
Option 2:
M1 and M2 channels are loaded with the same model material, M3/S slot is
loaded with another model material, and the S channel is loaded with
support.
Figure 4-7 Single material in M1 and M2, different material in M3,
support in S
Option 3:
M1 and M2 are loaded with different model materials, M3/S and S slots are
loaded with support cartridges.
4 Operating and Maintaining the Printer
4-5