Source Port - Cisco XR 1200 series Command Reference Manual

source port

source port
To identify the port of the source device, use the source port command in the appropriate configuration mode.
To use the unused port number, use the no form of this command.
source port port
no source port
Syntax Description
port port
Command Default
IP SLA uses an unused port that is allocated by system.
Command History
Releas
Release 3.3.0
Usage Guidelines
The source port command is not supported to configure ICMP operations; it is supported only to configure
UDP operations.
Task ID
Task ID
monitor
Examples The following example shows how to designate a port for the source port command in IP SLA UDP jitter
configuration mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp jitter
RP/0/0/CPU0:router(config-ipsla-udp-jitter)# source port 11111
Related Commands
Command
operation, on page 174
schedule operation, on page 215
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
252
Identifies the port number of the source device. Range is 1 to 65535.
Modification
This command was introduced.
Operations
read, write
Description
Configures an IP SLA operation.
Schedules an IP SLA operation.
IP Service Level Agreement Commands
OL-24735-01