Access-List - Cisco XR 1200 series Command Reference Manual

IP Service Level Agreement Commands

access-list

To specify an access-list name to filter provider edge (PE) addresses to restrict operations that are automatically
created by MPLS LSP monitor (MPLSLM) instance, use the access-list command in the appropriate
configuration mode. To return to the default value, use the no form of this command.
access-list acl-name
no access-list
Syntax Description
acl-name
Command Default
No access list is configured by default.
Command Modes
IP SLA MPLS LSP monitor ping configuration
IP SLA MPLS LSP monitor trace configuration
Command History
Release
Release 3.6.0
Usage Guidelines
Access-list changes are processed before the scan interval expires to display a planned list of changes in the
scan-queue.
There is no verification check between the access list and the IPSLA configuration.
Note
Task ID
Task ID
monitor
Examples The following example shows how to use the access-list command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# monitor 1
OL-24735-01
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Filters an access-list name.
Modification
This command was introduced.
Operations
read, write
access-list
115