Start-Time - Cisco XR 1200 series Command Reference Manual

IP Service Level Agreement Commands

start-time

To determine the time when the operation or MPLS LSP monitor instance starts, use the start-time command
in the appropriate configuration mode. To stop the operation and place it in the default state, use the no form
of this command.
start-time {hh:mm:ss [day| month day year]| after hh:mm:ss| now| pending}
no start-time
Syntax Description
hh:mm:ss
month
day
year
after hh:mm:ss
now
pending
Command Default
If a month and day are not specified, the current month and day are used.
Command Modes
IP SLA schedule configuration
IP SLA MPLS LSP monitor schedule configuration
Command History
Release
Release 3.3.0
Release 3.5.0
Release 3.7.0
OL-24735-01
Absolute start time in hours, minutes, and seconds. You can use the 24-hour clock
notation. For example, the start-time 01:02 is defined as 1:02 am, or start-time
13:01:30 is defined as start at 1:01 pm. and 30 seconds. The current day is used;
unless, you specify a month and day.
(Optional) Name of the month to start the operation. When you use the month
argument, you are required to specify a day. You can specify the month by using the
full English name or the first three letters of the month.
(Optional) Number of the day, in the range of 1 to 31, to start the operation. In addition,
you must specify a month.
(Optional) Year in the range of 1993 to 2035.
Specifies that the operation starts at hh hours, mm minutes, and ss seconds after the
start-time command is used.
Specifies that the operation should start immediately.
Specifies that no information is collected. The default value is the pending keyword.
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Modification
This command was introduced.
This command was added to IP SLA MPLS LSP monitor schedule
configuration mode.
Added the ability to specify a year.
start-time
253