React Lpd - Cisco XR 1200 series Command Reference Manual

IP Service Level Agreement Commands

react lpd

To specify that a reaction should occur if there is an LSP Path Discovery (LPD) violation, use the react lpd
command in the appropriate configuration mode. To use the default value, use the no form of this command.
react lpd {lpd-group| tree-trace} action logging
no react lpd {lpd-group| tree-trace}
Syntax Description
lpd-group
tree-trace
action
logging
Command Default
None
Command Modes
IP SLA MPLS LSP monitor configuration
Command History
Release
Release 3.6.0
Usage Guidelines
A status violation for a monitored LPD group happens when the Label Switched Path (LSP) group status
changes (with the exception of the status change from the initial state).
A path discovery violation for the monitored LPD group happens when path discovery to the target PE fails,
or successful path discovery clears such a failure condition.
Task ID
Task ID
monitor
OL-24735-01
Specifies that a reaction should occur if there is a status violation for the
monitored LPD group.
Specifies that a reaction should occur if there is a path discovery violation for
the monitored LPD group.
Configures the action to be taken on threshold violation.
Specifies the generation of a syslog alarm on threshold violation.
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Modification
This command was introduced.
Operations
read, write
react lpd
195