Cisco XR 1200 series Command Reference Manual page 252

show ipsla statistics aggregated
Table 24: show ipsla statistics aggregated Field Descriptions
Field
Busies
Entry Number
Hop in Path Index
Errors
Jitter Values
NumOfJitterSamples
Number of Failed Operations due to a Disconnect
Number of Failed Operations due to a Timeout
Number of Failed Operations due to a Busy
Number of Failed Operations due to a No Connection
Number of Failed Operations due to an Internal Error
Number of Failed Operations due to a Sequence Error
Number of Failed Operations due to a Verify Error
MaxOfNegativesSD
MaxOfPositivesSD
MaxOfPositivesDS
MaxOfNegativesDS
MinOfPositivesDS
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
240
IP Service Level Agreement Commands
Description
Number of times that the operation cannot be started
because the previously scheduled run was not
finished.
Entry number.
Hop in path index.
Number of internal errors.
Jitter statistics appear on the specified lines. Jitter is
defined as interpacket delay variance.
Number of jitter samples that are collected. The
number of samples are used to calculate the jitter
statistics.
Number of failed operations due to a disconnect.
Number of failed operations due to a timeout.
Number of failed operations due to a busy error.
Error that refers to the case in which the control
connection cannot be established.
Number of failed operations due to an internal error.
Number of failed operations due to a sequence error.
Number of failed operations due to a verify error.
Maximum negative jitter values from the source to
the destination. The absolute value is given.
Maximum jitter values from the source to the
destination in milliseconds.
Maximum jitter values from the destination to the
source in milliseconds.
Maximum negative jitter values from
destination-to-source. The absolute value is given.
Minimum jitter values from the destination to the
source in milliseconds.
OL-24735-01