Logging Correlator Ruleset - Cisco XR 1200 series Command Reference Manual

Alarm Management and Logging Correlation Commands

logging correlator ruleset

To enter correlation rule set configuration mode and define a correlation rule set, use the logging correlator
ruleset command in global configuration mode. To delete the correlation rule set, use the no form of this
command.
logging correlator ruleset correlation-ruleset rulename correlation-rulename
no logging correlator ruleset correlation-ruleset
Syntax Description
correlation-ruleset
rulename
correlation-rulename
Command Default
No rule sets are defined.
Command Modes
Global configuration
Command History
Release
Release 3.6.0
Usage Guidelines
The logging correlator ruleset command defines a specific correlation rule set. A rule set name must be
unique and is limited to a maximum length of 32 characters.
To apply a logging correlator rule set, use the
Examples This example shows how to specify a logging correlator rule set:
RP/0/0/CPU0:router(config)# logging correlator ruleset ruleset_1
RP/0/0/CPU0:router(config-corr-ruleset)# rulename state_rule
RP/0/0/CPU0:router(config-corr-ruleset)# rulename state_rule2
Related Commands
Command
logging correlator apply ruleset, on page 18
OL-24735-01
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Name of the correlation rule set to be applied.
Specifies the correlation rule name.
Name of the correlation rule name to be applied.
Modification
This command was introduced.
logging correlator apply ruleset, on page 18
Description
Applies and activates a correlation rule set and enters
correlation apply rule set configuration mode.
logging correlator ruleset
command.
25