Table of Contents
Advertisement
Installing and Connecting the Router
Warning
Warning
Warning
Warning
Warning
Warning
Caution
Warning
Statement 191 Voluntary Control Council for Interference (VCCI) Class A
Warning for Japan
Warning
Statement 191 Voluntary Control Council for Interference (VCCI) Class A Warning for Japan
To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Statement 1023
Use copper conductors only. Statement 1025
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement
1022
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
not view directly with optical instruments. Viewing the laser output with certain optical instruments
(for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye
hazard. Statement 1056
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of: 60°C (140°F). Statement 1047
Hot surface. Statement 1079
Heat sinks applicable to warning statement 1079, can exceed 90º C in a 60º C ambient. Suitable
precautions should be taken to avoid burns.
This equipment needs to be grounded. Use a green and yellow 12 to 14 AWG ground wire to connect
the host to earth ground during normal use. Statement 242
This is a Class A product based on the standard of the VCCI Council. If this equipment is used in a domestic
environment, radio interference may occur, in which case, you may be required to take corrective actions.
Cisco Catalyst IR8340 Rugged Series Router Hardware Installation Guide
25
Advertisement
Table of Contents
