IP Service Level Agreement Commands
scan interval
To specify the frequency at which the MPLS LSP monitor (MPLSLM) instance checks the scan queue for
updates, use the scan interval command in the appropriate configuration mode. To return to the default value,
use the no form of this command.
scan interval scan-interval
no scan interval
Syntax Description
scan-interval
Command Default
interval: 240 minutes
Command Modes
IP SLA MPLS LSP monitor ping configuration
IP SLA MPLS LSP monitor trace configuration
Command History
Release
Release 3.5.0
Usage Guidelines
Use the scan interval command to specify a frequency value in minutes at which the MPLS LSP monitoring
instance checks the scan queue for PE updates. Updates from PE discovery are not processed immediately,
but rather stored in a scan queue for batched processing at periodic intervals, specified by this value.
Task ID
Task ID
monitor
Examples
The following example shows how to use the scan command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# monitor 1
RP/0/0/CPU0:router(config-ipsla-mplslm-def)# type mpls lsp ping
RP/0/0/CPU0:router(config-ipsla-mplslm-lsp-ping)# scan interval 120
OL-24735-01
Time interval between provider edge (PE) router updates. Range is
1 to 70560.
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Modification
This command was introduced.
Operations
read, write
scan interval
211