Datasize Request - Cisco XR 1200 series Command Reference Manual

datasize request

datasize request
To set the protocol data size in the request packet in the payload of an operation, use the datasize request
command in the appropriate configuration mode. To reset the default data size, use the no form of this
command.
datasize request size
no datasize request
Syntax Description
size
Command Default
For a UDP jitter operation, the default value is 32 B.
For a UDP echo operation, the default value is 16 B.
For an ICMP echo operation, the default value is 36 B.
For an ICMP path-echo operation, the default value is 36 B.
For an ICMP path-jitter operation, the default value is 36 B.
For an MPLS LSP ping operation, the default value is 100 B.
Command Modes
IP SLA UDP echo configuration
IP SLA UDP jitter configuration
IP SLA ICMP path-jitter configuration
IP SLA ICMP path-echo configuration
IP SLA ICMP echo configuration
IP SLA MPLS LSP ping configuration
Command History
Release
Release 3.3.0
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
128
Specifies the following ranges and default values that are protocol dependent:
• For a UDP jitter operation, range is 16 to 1500 B.
• For a UDP echo operation, range is 4 to 1500 B.
• For an ICMP echo operation, range is 0 to 16384 B.
• For an ICMP path-echo operation, range is 0 to 16384 B.
• For an ICMP path-jitter operation, range is 0 to 16384 B.
• For an MPLS LSP ping operation, range is 100 to 17986 B.
Modification
This command was introduced.
IP Service Level Agreement Commands
OL-24735-01