Table of Contents
Advertisement
performance-mgmt apply thresholds
Command Default
Threshold collection is disabled.
Command Modes
Global configuration
Command History
Release
Release 2.0
Release 3.2
Release 3.3.0
Release 4.0.1
Usage Guidelines
Use the performance-mgmt apply thresholds command to apply a threshold template and enable threshold
collection. Several templates can be configured, but only one template for each entity can be enabled at a
time.
Use the no form of the command to disable threshold collection. Because only one performance management
threshold monitoring template can be enabled for any given entity at any given time, you are not required to
specify the template name with the default keyword or template keyword and template-name argument when
disabling a performance management statistics collection.
For information about creating threshold templates, see the
command.
Task ID
Task ID
monitor
Examples
This example shows how to start threshold collection for BGP using a template named stats1:
RP/0/0/CPU0:router(config)#performance-mgmt apply thresholds bgp stats1
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
378
Modification
This command was introduced.
The enable keyword was replaced by the apply keyword. In previous releases,
this command was referred to as performance-mgmt enable thresholds .
The disable keyword was deprecated.
The ospf v2protocol and ospf v3protocol keywords were introduced to
support the enabling of threshold monitoring templates for the OSPF entity.
The location keyword was added. The global keyword was deprecated and
replaced by the location all keywords.
Removed support for MPLS interfaces.
The interface basic-counters keyword was added to support the enabling of
threshold monitoring template for the basic counter.
Operations
read, write, execute
Performance Management Commands
performance-mgmt thresholds, on page 389
OL-24735-01
Advertisement
Table of Contents
