Cisco XR 1200 series Command Reference Manual page 157

IP Service Level Agreement Commands
The frequency value must be greater than or equal to the schedule period.
This configuration is inherited automatically by all LSP operations that are created.
Task ID
Task ID
monitor
Examples
The following example shows how to use the frequency command in IP SLA UDP jitter configuration mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp jitter
RP/0/0/CPU0:router(config-ipsla-udp-jitter)# frequency 300
The following example shows how to use the frequency command in IP SLA MPLS LSP monitor schedule
configuration mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# schedule monitor 1
RP/0/0/CPU0:router(config-ipsla-mplslm-sched)# frequency 1200
RP/0/0/CPU0:router(config-ipsla-mplslm-sched)# schedule period 600
Related Commands
Command
operation, on page 174
schedule operation, on page 215
schedule period, on page 217
OL-24735-01
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Operations
read, write
Description
Configures an IP SLA operation.
Schedules an IP SLA operation.
Configures the amount of time during which all LSP
operations are scheduled to start or run.
frequency (IP SLA)
145