Lsr-Path - Cisco XR 1200 series Command Reference Manual

lsr-path

lsr-path
To specify a loose source routing path in which to measure the ICMP, use the lsr-path command in the
appropriate configuration mode. To use a path other than the specified one, use the no form of this command.
lsr-path ipaddress1 [ipaddress2 [... [ipaddress8]]]
no lsr-path
Syntax Description
ip address
Command Default
No path is configured.
Command Modes
IP SLA ICMP path-jitter configuration
IP SLA ICMP path-echo configuration
Command History
Release
Release 3.3.0
Usage Guidelines
The lsr-path command applies only to ICMP path-echo and ICMP path-jitter operation types.
You can configure up to a maximum of eight hop addresses by using the lsr-path command, as shown in the
following example:
lsr-path ipaddress1 [ipaddress2 [... [ipaddress8]]]
Task ID
Task ID
monitor
Examples The following example shows how to use the lsr-path command in IP SLA ICMP Path-echo configuration
mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type icmp path-echo
RP/0/0/CPU0:router(config-ipsla-icmp-path-echo)# lsr-path 192.0.2.40
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
162
IPv4 address of the intermediate node. Up to eight addresses can be entered.
Modification
This command was introduced.
Operations
read, write
IP Service Level Agreement Commands
OL-24735-01