Type Icmp Path-Jitter - Cisco XR 1200 series Command Reference Manual

IP Service Level Agreement Commands

type icmp path-jitter

To use the ICMP path-jitter operation type, use the type icmp path-jitter command in IP SLA operation
configuration mode. To remove the operation, use the no form of this command.
type icmp path-jitter
no type icmp path-jitter
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
IP SLA operation configuration
Command History
Release
Release 3.3.0
Usage Guidelines
Task ID
Task ID
monitor
Examples The following example shows how to use the type icmp path-jitter command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type icmp path-jitter
RP/0/0/CPU0:router(config-ipsla-icmp-path-jitter)#
Related Commands
Command
operation, on page 174
schedule operation, on page 215
OL-24735-01
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Modification
This command was introduced.
Operations
read, write
Description
Configures an IP SLA operation.
Schedules an IP SLA operation.
type icmp path-jitter
285