Maximum Hops - Cisco XR 1200 series Command Reference Manual

maximum hops

maximum hops
To set the number of hops in which statistics are maintained for each path for the IP SLA operation, use the
maximum hops command in IP SLA operation statistics configuration mode. To use the default value, use
the no form of this command.
maximum hops hops
no maximum hops
Syntax Description
hops
Command Default
The default value is 16 hops.
Command Modes
IP SLA operation statistics configuration
Command History
Release
Release 3.3.0
Usage Guidelines
The maximum hops command is supported only when you configure path operations and the IP SLA ICMP
path-echo operation.
Task ID
Task ID
monitor
Examples The following example shows how to set the number of hops for the statistics for the maximum command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type icmp path-echo
RP/0/0/CPU0:router(config-ipsla-icmp-path-echo)# statistics hourly
RP/0/0/CPU0:router(config-ipsla-op-stats)# maximum hops 20
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
164
Number of hops for which statistics are maintained for each path. Range is 1 to 30. Default
value is 16 for path operations; for example, pathecho.
Modification
This command was introduced
IP Service Level Agreement Commands
Operations
read, write
OL-24735-01