Table of Contents
Advertisement
IP Service Level Agreement Commands
buckets (statistics interval)
To specify the maximum number of buckets in which the enhanced history statistics are kept, use the buckets
command in IP SLA operation statistics configuration mode. To remove the statistics collection of the specified
interval, use the no form of this command.
buckets bucket-size
no buckets
Syntax Description
bucket-size
Command Default
The default value is 100.
Command Modes
IP SLA operation statistics configuration
Command History
Release
Release 3.3.0
Usage Guidelines
The buckets command with the bucket-size argument is valid only for the statistics command with the interval
keyword.
Examples
The following example shows how to collect statistics for a given time interval for the IP SLA UDP jitter
operation for the buckets command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp jitter
RP/0/0/CPU0:router(config-ipsla-udp-jitter)# statistics interval 60
RP/0/0/CPU0:router(config-ipsla-op-stats)# buckets 50
Related Commands
Command
statistics, on page 256
OL-24735-01
The bucket size is when the configured bucket limit is reached. Therefore, statistics
gathering for the operation ends. Range is 1 to 100. Default is 100.
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Modification
This command was introduced.
Description
Sets the statistics collection parameters for the
operation.
buckets (statistics interval)
125
Advertisement
Table of Contents
