Reaction Trigger - Cisco XR 1200 series Command Reference Manual

IP Service Level Agreement Commands

reaction trigger

To define a second IP SLA operation to make the transition from a pending state to an active state when one
of the trigger-type options is defined with the reaction operation command, use the reaction trigger command
in IP SLA configuration mode. To remove the reaction trigger when the triggering-operation argument does
not trigger any other operation, use the no form of this command.
reaction trigger triggering-operation triggered-operation
no reaction trigger triggering-operation triggered-operation
Syntax Description
triggering-operation
triggered-operation
Command Default
No triggered operation is configured.
Command Modes
IP SLA configuration
Command History
Release
Release 3.3.0
Usage Guidelines
Both the triggering-operation and triggered-operation arguments must be configured. The triggered operation
must be in the pending state.
Task ID
Task ID
monitor
Examples The following example shows how to use the ipsla reaction trigger command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# reaction trigger 1 2
OL-24735-01
Operation that contains a configured action-type trigger and can generate
reaction events. Range is 1 to 2048.
Operation that is started when the triggering-operation argument generates
a trigger reaction event. Range is 1 to 2048.
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Modification
This command was introduced.
Operations
read, write
reaction trigger
201