Scan Delete-Factor - Cisco XR 1200 series Command Reference Manual

Cisco ios xr system monitoring command reference
Table of Contents

Advertisement

IP Service Level Agreement Commands

scan delete-factor

To specify the frequency with which the MPLS LSP monitor (MPLSLM) instance searches for provider edge
(PE) routers to delete, use the scan delete-factor command in the appropriate configuration mode. To return
to the default value, use the no form of this command.
scan delete-factor factor-value
no scan delete-factor
Syntax Description
factor-value
Command Default
factor-value: 1
Command Modes
IP SLA MPLS LSP monitor ping configuration
IP SLA MPLS LSP monitor trace configuration
Command History
Release
Release 3.5.0
Usage Guidelines
The scan delete-factor command specifies a factor value for automatic PE deletion. The specified factor-value
is multiplied by the scan interval to acquire the frequency at which the MPLS LSP monitoring instance deletes
not-found PEs. A scan delete factor of zero (0) means that provider edge (PE) routers that are no longer valid
are never removed.
Task ID
Task ID
monitor
Examples
The following example shows how to use the scan delete-factor command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# monitor 1
OL-24735-01
Specifies a factor that is multiplied by the scan interval to determine the frequency at
which the MPLS LSP monitor instance deletes the provider edge (PE) routers that are
no longer valid. Range is 0 to 2147483647.
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Modification
This command was introduced.
Operations
read, write
scan delete-factor
209

Advertisement

Table of Contents
loading

Table of Contents