Responder - Cisco XR 1200 series Command Reference Manual

IP Service Level Agreement Commands

responder

To enable the IP SLA responder for UDP echo or jitter operations, use the responder command in IP SLA
configuration mode. To disable the responder, use the no form of this command.
responder
no responder
Syntax Description
This command has no keywords or arguments.
Command Default
The IP SLA responder command is disabled.
Command Modes
IP SLA configuration
Command History
Release
Release 3.3.0
Usage Guidelines
An IP address and port are configured and identified as a permanent port (for example, a port to which the
responder is permanently listening). If no IP address and port are configured, the responder handles only
dynamic ports (for example, ports that are listened to when requested by a remote operation).
Task ID
Task ID
monitor
Examples The following example shows how to enable the IP SLA responder:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# responder
RP/0/0/CPU0:router(config-ipsla-resp)#
Related Commands
Command
type udp ipv4 address, on page 292
OL-24735-01
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Modification
This command was introduced.
Operations
read, write
Description
Configures a permanent port in the IP SLA Responder
for UDP echo or jitter operations.
responder
203