Table of Contents
Advertisement
Onboard Failure Logging Commands
• To enable OBFL and return the configuration to the default message severity level, use the no form of
When the OBFL feature is disabled, existing OBFL logs are preserved. To resume OBFL data collection,
enable the OBFL feature again.
If a new node is inserted, and OBFL is enabled for that slot, then OBFL is enabled for the new node. If a
Note
card is removed from a router and inserted into a different router, the card assumes the OBFL configuration
for the new router.
Examples
The following example shows how to disable OBFL for all cards:
RP/0/0/CPU0:router(admin-config)# hw-module all logging onboard disable
The following example shows how to disable OBFL for a card:
RP/0/0/CPU0:router(admin-config)# hw-module subslot 0/2/CPU0 logging onboard disable
The following example shows how to enable OBFL again:
RP/0/0/CPU0:router(admin-config)# no hw-module all logging onboard disable
The following example shows how to save only the syslog message in which the severity level is set to 0
(emergency) to a storage device:
RP/0/0/CPU0:router(admin-config)# hw-module subslot 0/2/CPU0 logging onboard severity
emergencies
The following example shows how to save the syslog message in which the severity level is set to 0 (emergency)
and 1 (alert) to a storage device:
RP/0/0/CPU0:router(admin-config)# hw-module subslot 0/2/CPU0 logging onboard severity alerts
Related Commands
Command
clear logging onboard, on page 354
show logging onboard, on page 358
OL-24735-01
the hw-module logging onboard command with the severity keyword:
no hw-module {all | subslot node-id} logging onboard severity
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
hw-module logging onboard
Description
Clears OBFL logging messages from a node or from
all nodes.
Displays the OBFL messages.
357
Advertisement
Table of Contents
