Cisco XR 1200 series Command Reference Manual page 301

IP Service Level Agreement Commands
MPLS LSP monitor configuration mode, it configures the parameters for all operations associated with the
monitored provider edge (PE) routers. This configuration is inherited by all LSP operations that are created
automatically.
Task ID
Task ID
monitor
Examples The following example shows how to use the type mpls lsp trace command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type mpls lsp trace
RP/0/0/CPU0:router(config-ipsla-mpls-lsp-trace)#
The following example shows how to use the type mpls lsp trace command in IP SLA MPLS LSP monitor
configuration mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# monitor 2
RP/0/0/CPU0:router(config-ipsla-mplslm-def)# type mpls lsp trace
RP/0/0/CPU0:router(config-ipsla-mplslm-lsp-trace)#
Related Commands
Command
operation, on page 174
schedule monitor, on page 213
schedule operation, on page 215
type mpls lsp ping, on page 286
OL-24735-01
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
Operations
read, write
Description
Configures an IP SLA operation.
Schedules an IP SLA MPLS LSP monitoring instance.
Schedules an IP SLA operation.
Tests connectivity in an LSP path in an MPLS VPN.
type mpls lsp trace
289