Table of Contents
Advertisement
Parameters
ip-address: Specifies the Web authentication-free subnet address.
mask-length: Specifies the mask length of the Web authentication-free subnet address, in the range
of 0 to 32.
mask: Specifies a mask for the Web authentication-free subnet in dotted decimal notation.
all: Specifies all Web authentication-free subnets.
User guidelines
Web authentication users can access resources in Web authentication-free subnets without being
authenticated.
You can repeat this command to configure multiple Web authentication-free subnets.
Examples
# Configure subnet 192.168.0.0/24 as a Web authentication-free subnet.
<Sysname> system-view
[Sysname] web-auth free-ip 192.168.0.0 24
web-auth max-user
Use web-auth max-user to set the maximum number of Web authentication users allowed on an
interface.
Use undo web-auth max-user to restore the default.
Syntax
web-auth max-user max-number
undo web-auth max-user
Default
The maximum number of Web authentication users on an interface is 1024.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
mdc-admin
Parameters
max-number: Specifies the maximum number of Web authentication users allowed on an interface.
The value range for this argument is 1 to 2048.
User guidelines
If the specified maximum number is smaller than the number of current online Web authentication
users on the interface, the limit can be set successfully. The limit does not impact the online Web
authentication users. However, the device does not allow new Web authentication users to log in
from the interface until the number drops down below the limit.
This command specifies the maximum number of only IPv4 Web authentication users.
Examples
# On Ten-GigabitEthernet 1/0/1, set the maximum number of Web authentication users to 32.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
707
Advertisement
Table of Contents
