Ipv4 Urpf Commands - HP FlexNetwork 7500 Series Command Reference Manual

IPv4 uRPF commands

display ip urpf
Use display ip urpf to display uRPF configuration.
Syntax
In standalone mode:
display ip urpf [ slot slot-number ]
In IRF mode:
display ip urpf [ chassis chassis-number slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
displays uRPF configuration for all cards. (In standalone mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The
chassis-number argument represents the member ID of the IRF member device. The slot-number
argument represents the slot number of the card. If you do not specify a card, this command displays
uRPF configuration for all cards. (In IRF mode.)
Examples
# (In standalone mode.) Display uRPF configuration for the specified slot.
<Sysname> display ip urpf slot 1
Global uRPF configuration information(failed):
Check type: strict
Allow default route
Table 98 Command output
Field
(failed)
Check type
Allow default route
ip urpf
Use ip urpf to enable uRPF.
Description
The system failed to deliver the uRPF configuration to the
forwarding chip because of insufficient chip resources.
This field is not displayed if the delivery is successful.
uRPF check mode: loose or strict.
Using the default route is allowed.
654