Web Authentication Commands - HP FlexNetwork 7500 Series Command Reference Manual

Web authentication commands

display web-auth
Use display web-auth to display Web authentication configuration and running status on interfaces.
Syntax
display web-auth [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. If you do
not specify an interface, this command displays Web authentication configuration for all interfaces.
Examples
# Display Web authentication configuration on Ten-GigabitEthernet 1/0/1.
<Sysname> display web-auth interface ten-gigabitethernet 1/0/1
Global Web-auth parameters
Proxy Port Numbers
Total online web-auth users: 1
Ten-GigabitEthernet1/0/1
Port role
Web-auth domain
Auth-Fail VLAN
Offline-detect
Max online users
Web-auth enable
Total online web-auth users: 1
Table 107 Command output
Field
Global Web-auth parameters
Proxy Port Numbers
Total online web-auth users
Ten-GigabitEthernet1/0/1 is
link-up
Port role
:
: Not configured
is link-up
: Authenticator
: my-domain
: Not configured
: Not configured
: 1024
: Enabled
Description
Global Web authentication configuration.
Port numbers of the Web proxy servers.
Total number of online Web authentication users on the device.
State of the interface:
•
link-up—The interface is both administratively and physically up.
•
link-down—The interface is down.
Role of the port. The port functions only as an Authenticator.
697