Dot1X Supplicant Eap-Method - HP FlexNetwork 7500 Series Command Reference Manual

•
TTLS-GTC.
If the MD5-Challenge EAP authentication is used, the configured 802.1X client anonymous identifier
does not take effect. The device uses the 802.1X client username at the first authentication phase.
Do not configure the 802.1X client anonymous identifier if the vendor-specific authentication server
cannot identify anonymous identifiers.
Examples
# Configure the 802.1X client anonymous identifier as bbb on a port.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] dot1x supplicant anonymous identify bbb
Related commands
display dot1x supplicant
dot1x supplicant enable
dot1x supplicant username

dot1x supplicant eap-method

Use dot1x supplicant eap-method to specify an 802.1X client EAP authentication method.
Use undo dot1x supplicant eap-method to restore the default.
Syntax
dot1x supplicant eap-method { md5 | peap-gtc | peap-mschapv2 | ttls-gtc | ttls-mschapv2 }
undo dot1x supplicant eap-method
Default
The MD5-Challenge authentication is used as the 802.1X client EAP authentication method.
Views
Ethernet interface view
Predefined user roles
network-admin
mdc-admin
Parameters
md5: Specifies the MD5-challenge EAP authentication method.
peap-gtc: Specifies the PEAP-GTC EAP authentication method.
peap-mschapv2: Specifies the PEAP-MSCHAPv2 EAP authentication method
ttls-gtc: Specifies the TTLS-GTC EAP authentication method.
ttls-mschapv2: Specifies the TTLS-MSCHAPv2 EAP authentication method.
Usage guidelines
Make sure the specified 802.1X client EAP authentication method is supported by the authentication
server.
Examples
# Specify PEAP-GTC as the 802.1X client EAP authentication method on a port.
<Sysname> system-view
691