Automatic Mode Operation; Main Program Selection And Operation - Okuma OSP-U100M Operation Manual

4203-E P-76
SECTION
5
AUTOMATIC
MODE OPERATION
SECTION
5
AUTOMATIC MODE OPERATION
Main Program Selection and Operation 1.
In order
to
execute a
part program in the automatic mode, first select the part program. Programs stored in
the memory have their own file names since programs are managed as files. The specified main program
is read from the part programs stored in the file and the subprogram, called in the main program, is
searched out in the specified sub file to be loaded
to the NC.
For the selection of file, the directory-selection-based file
operation
screen
is used.
The following explanation gives basic information on program selection
operation. In addition to the basic
information given below, there are various functions including the function to display the registered part
program files in batch. For details of the functions, refer
to III. DATA OPERATION, Section
2, 15.
"Directory-Selection-Based File Operation Function".
The operating procedure
is described below:
(1) Press the AUTO key.
-
lAUTQj
(2) The lamp at the
upper left corner in the key lights and the screen changes
to the automatic
operation screen.
Press function key [FI] (PROGRAM SELECT).
PROGRAM ACTUAL PART BLOCK
SELECT POSIT. PROGRAM DATA
SEARCH
CHECK
[EXTEND]
J
DATA
F1
1
F2
(
F3
1 [
F4 F5
1 [
F6
} [
F7
1
F8
Press [F1] (PROGRAM SELECT).