Precautions Relating To The Atc; On Finishing Work - Okuma OSP-U100M Operation Manual

ME00-001-R1 P-(iii)
SAFETY PRECAUTIONS
4.
Precautions Relating to the ATC
(1) The tool clamps of the magazine,
spindle, etc., are designed for reliability, but it is possible that
a tool could be released and fall
in the event of an unforeseen accident, exposing you
to
danger: do not touch or approach the ATC mechanism during ATC operation.
(2) Always inspect and change tools in the magazine in the manual magazine interrupt mode.
(3) Remove chips adhering to the magazine
at appropriate intervals since they
can cause
misoperation.
Do not
use
compressed air to remove these chips since it will
only push the
chips further in.
(4) If the ATC stops during operation for some reason and it has
to
be inspected without turning the
power off, do not touch the ATC since it may start moving suddenly.
5.
On Finishing Work
(1) On finishing work, clean the vicinity of the machine.
(2) Return the ATC, APC and other equipment to the predetermined retraction position.
(3) Always turn off the power to the machine before leaving it.
(4)
To turn off the power, turn off the CONTROL ON switch on the operation
panel
first, then the
main power disconnect switch.