Data Setting Mode - Okuma OSP-U100M Operation Manual

4203- E P-158
SECTION
1
DATA SETTING
(2) Data Setting Mode
(a) EDIT/AUX
This is the mode for reading, editing, punching-out, and printing
out
the program, operating the
tape reader, and managing files.
(b) PARAMETER
Parameters and variables, including system parameters, user
parameters,
common variables
and NC optional
parameters
are
set.
For details of the parameters, refer to IV "PARAMETER" in this manual.
(c) TOOL DATA
Used to set the tool data such as tool length offset values and cutter radius
compensation values.
(d) ZERO SET
In this mode, the work zero offset value is set.
(3) MacMan Mode
The actual status of the production field is collected in this mode, andthe result of data processing is
output to the NC screen, printer, or 3.5-inch floppy disk.
For details of the MacMan mode, refer
to the separately
prepared manual, "MacMan
INSTRUCTION MANUAL".
(4) Pressing any of the mode operation selection keys will light the lamp in the key.
(5) If the mode is switched from any of the operation modes to the data setting mode, the lamp in
the selected operation mode
key starts flashing. This
allows the operator
to recognize the
selected operation mode at a glance.
(6) Once program execution is started in the
AUTO
mode or MDI mode, switching the mode
to
Data Setting Mode, such as EDIT/AUX, PARAMETER, TOOL DATA, and ZERO SET, will not
interrupt the program execution. Therefore, program editing, tape punching-out, tape
reading-in, parameter setting, zero setting, tool data setting and other data setting
operations
are
possible during stored program execution.
When program execution halts in the AUTO mode operation, while data setting operation is being
carried out, due to Single Block ON or Program Stop command, it is necessary to press the CYCLE
START switch after switching the mode
to
AUTO to continue the AUTO mode operation.
(7) Switching the operation modes in the following sequence will reset the control:
(a) From manual to
auto or MDI
(b) From auto or MDI
to
manual
(c) When the mode is switched from manual to the data setting
mode,
although the control is
not
reset, it is reset when any operation is selected after that.
: When the data has been
set,
the new data is stored in memory after two to three
minutes
have passed. Therefore,
if the power is turned off immediately after the data has been
set, the data may not be updated as desired.
Before turning off the power supply and after setting the data, backup the data following the
procedure explained in 3-4-1. "Back Up Command".