Operation End Buzzer (Option); Error Light (Option); Auto Power Off (Option); Work Counter (Option) - Okuma OSP-U100M Operation Manual

4203-E P-112
SECTION
5 AUTOMATIC MODE OPERATION
20.
Operation End Buzzer (Option)
Operates in the same conditions as the operation end light. The operation end buzzer sounds when
these
conditions have been satisfied. Note that the setting for the related machine user
parameter must be set
"effective".
The operation end buzzer sounds for the length of
time set
for machine user parameter, "Buzzer, 7.
Operation end buzzer timer".
Restarting will cut off the operation end buzzer.
21
.
Error Light (Option)
The ERROR
lamp is
turned on
at the occurrence of an alarm. Note that the setting for the related machine
user parameter must be set "effective".
The lamp is turned off when the NC is
reset.
22. Auto Power Off (Option)
The power is shut down when the following conditions are satisfied. Note that the setting for the related
machine user parameter must be set "effective".
Mode Condition
Automatic operation
Single block off
(1) Schedule program after executing END in a schedule program
(2)
Main program after executing M02 or M30 in a main program
When this function is used and there are blocks
changing/setting parameters on the program, it is
recommended
to
make the backup function effective with
M02/M03 (Set "1" at NC optional parameter (bit)
No. 33, bit 1).
23.
Work Counter (Option)
Count data
is
incremented
when
the machining completion signal
(M02 or M30) is executed. The counter
has a six-digit capacity (0 to 999999). It is provided with the reset function.
Dt
000000
\
Reset button