Automatic Apc Operations; Manual Apc Operations - Okuma OSP-U100M Operation Manual

4203- E P-69
SECTION
3 MANUAL OPERATION FUNCTIONS
5-2.
Automatic
APC Operations
(1) Pallet Change
Automatic pallet change cycle is carried out by executing the M60 command.
(2) Workpiece Setup Completion
The automatic pallet change cycle is carried out after the workpiece setup has been confirmed. This
setup completion condition is confirmed by pressing the
WORK LOAD FINISHED button.
The WORK LOAD FINISHED button is located on the operation panel and also on the separately
installed APC operation panel (option). Both of these buttons have the same function. When the
WORK LOAD FINISHED button is pressed, its indicating lamp lights.
Even when the
automatic pallet change M code command is
read
while the workpiece
setup
completion is not confirmed (lamp OFF), the APC does not operate. In this case, the diagnosis
message tells that the workpiece setup is not confirmed. Press the WORK LOAD FINISHED button
after making sure that the workpiece has been
set
on the pallet.
In the manual mode, the control is always
in the state that the WORK LOAD FINISHED button
is
pressed.
(3)
WORK LOAD RESET Pushbutton Switch
If the WORKLOAD FINISHED button is
pressed
mistakenly while a workpiece has not been
set on
the pallet, this setup completion confirmation
state
can be cancelled
by pressing the WORK LOAD
RESET button.
The WORK LOAD RESET button is located
on the operation panel and also on the separately
installed APC
operation
panel (option). Both of
these buttons
have the same function. When the
WORK LOAD RESET button is pressed, its indicating lamp goes
off.
The workpiece
setup completed state cannot be cancelled by pressing the RESET button.
5-3.
Manual APC Operations
Manual pallet changer operation is possible when the MANUAL INT. switch
is set at
the ON position.
(1)
Parallel or Rotary Type 2-Pallet APC (Vertical/Horizontal Machining
Center)
APC OPERATION
o
o
SET UP COMPLETION
CYCLE START
OFF
ON
o
EMG. STOP
SLIDE HOLD DOOR
OPEN
CLOSE
Fig. 3-4 APC Operation Panel
-
Parallel or Rotary Type 2-pallet APC
(Vertical/Horizontal Machining Center)