Manual Intervention During Automatic Operation And Restart - Okuma OSP-U100M Operation Manual

4203-E P-105
SECTION
5
AUTOMATIC MODE OPERATION
14. Manual Intervention During Automatic Operation and Restart
Manual intervention refers
to
the function in which manual operation is performed during AUTO or MDI
mode operations.
(1) During the AUTO or MDI mode operation, press either the SLIDE HOLD switch or the SINGLE
BLOCK switch
to stop the cycle.
(2) Press the MANUAL INT ON switch.
The control is now placed in the manual intervention mode.
(3) Carry
out
necessary manual
operations.
-
Manual axis cutting feed
-
Manual axis rapid feed
-
Manual
axis
feed by pulse handle
-
Spindle rotation
-
Tool change,
etc.
After manual axis feed, that distance is displayed on the display screen
-
2nd page of ACT POSIT
pages:
[Display screen]
MANUAL SHIFT ACTUL
Manually shifted
amount in the present manual intervention
operation
A total of manually shifted amounts until the
present
manual
intervention operation
(4)
Before restarting the sequence operation, restore the miscellaneous functions
to
the
previous
conditions, and locate the axes near the
position
where
the intervention has been made using
manual cutting feed or pulse handle. Then, press the SEQ. RESTART switch. With this,
the
axes
return to
the original position. The data displayed at MANUAL SHIFT ACTUL will become
zero
at the same
time.
MANUAL SHIFT TOTAL
ACMTION
'
th's return operation,
the axes are fed
at a rapid feedrate. Therefore, it is necessary to
-
confirm
that
the
return
motion will
not
cause interference between the
spindle or the
cutting tool with the workpiece or the fixture on the table.
If the SEQ. RESTART switch is not pressed, the manually fed amount is not zeroed.