Operation End Light (Option) - Okuma OSP-U100M Operation Manual

4203-E P-111
SECTION
5
AUTOMATIC MODE OPERATION
(4) Initializing Library Program
Press function key [F1] (LIBRARY P.SET) and key in as follows:
LPI_I ;l [WRITE]
With the operation above, the programs registered as library programs are all deleted.
(5) Specifying Buffer Size of Library Program
Press function key [F1] (LIBRARY P.SET) and key in as follows:
LP
I_J
n;l [WRITE]
With the operation above, the buffer size of "n" bytes for registering the library programs
is ensured.
Note that when the buffer size specification is changed, the library program registration
state and
the program selection state are all cleared.
To ensure the NC program registration area for
operation
without using library programs as
much as
practicable, zero the library program registration by the operation below.
Press function key [F1] (LIBRARY P. SET) and key in as follows:
LPI_J 0; I [WRITE]
The library programs registered in
the operations above, can be accessed by the required MDI
mode operation. They can also be referenced in the S option mode or the equivalent operation
mode (DNC, for instance).
(6) The subprograms in the file which have an extension LIB are automatically registered as library
programs when power supply
to the control is turned on. Therefore, G code macro or other
subprograms which are frequently used are recommended to be stored
in
the LIB file. This
permits
them to be called any time as conventional G codes.
NOTICE
: (1) A library program is distinguished only by its program name. Therefore, it
is impossible to
register more than one library program which have the same
name.
If the subprogram in the user program has the same name as the library program, the
library program is given priority when such a subprogram is intended
to be called.
(2) Turn off and on the power alter
adding a new library program.
19.
Operation End Light (Option)
The operation end light goes on when the following conditions have been satisfied. Note thatthe setting for
the related machine user parameter must be set "effective".
Mode
Condition
Automatic
operation
Single block off
When program is completed
(1)
schedule program after executing END
in a schedule program.
(2) main program after executing MOO, M01
,
M02 or M30 in a main program.
Restarting will extinguish the operation end light.
When the alarm
occurs,
resetting the CNC unit will extinguish the operation end light.