Axis Change Command; Cursor Keys; Page Keys - Okuma OSP-U100M Operation Manual

4203-E P-164
SECTION
1
DATA SETTING
3-2-3.
AXIS CHANGE Command
=AX
AXIS
[EXTEND]ÿ/ SEARCH
CHANGE ITEM
t
ITEM
I
SET ADD
CAL
FI
[
F2
[
F3 F4 F5 F6
1
F7
1 [
F8
"AX" is displayed.
Each time [F5] (AXIS CHANGE)
is pressed,
the screen
is switch
over
to
the next axis display.
In data setting, if there is a parameter of axis type, the 5th and 6th axes cannot be displayed on the same
screen. The AXIS CHANGE command is intended to switch the screen from one display
to another.
Since the pitch error compensation data may be displayed on one axis per screen, the command is used
for axis selection.
When function key [F5] is pressed, "AX" appears on the 21st line on the display screen, resulting in a
screen
switch.
3-2-4.
Cursor Keys
@©
@@
Move the cursor in the arrow-pointed direction, where the cursor stays at only the points including data to
be set. When, for example, the cursor
is at
rest at
the
extreme
left, press the cursor key
(?)
;
this brings the cursor
to
the data element located at the extreme right, When the cursor is
at the
extreme right, press the cursor key
(ÿ)
;
this
brings the cursor to the data element located at the extreme left. A similar relationship exists between
the
cursor keys
@
and
@
.
3-2-5.
Page Keys
®(jD
When the
(Qg)
key is pressed, the
screen advances one page
in the same category only.
When the
(8B)
key is pressed, the screen returns one page in the same category only.