Other Controls On Nc Operation Panel - Okuma OSP-U100M Operation Manual

4203-E P-39
SECTION 1 OPERATION
2-4.
Other Controls on NC Operation Panel
(1)
Function Keys: F1 to F8
When an operator selects a desired operation mode, the screen displays
the necessary operation functions
at
the bottom line. Each function
corresponds to
a function key
(F1 through F8). Select the function to
execute and press the corresponding function key.
The functions assigned to the function keys change according to the
currently valid mode as the operation progresses.
(2) ? (Help) Key
This key, called the help key, is provided
to the left side of function key
BE
[FI].
The key is used to display the description of the
alarm
which occurred
during machine operation and also the alarm history.
(3) Display Screen
The display screen has the information display area of
64
characters x
24
lines.
It shows actual position data, part program data, block data, zero offset
values, tool offset values, parameter data, alarm description, etc.
The basic format of display on the screen is shown below.
1st line:
Mode currently selected (guide display)
Current date and time
7ÿ
7
2nd line:
Alarm
contents
3rd line to 18th line: Data
19th line to 22nd line:
Console lines (display of input data)
23rd line
to 24th line:
J j
j j
Effective function of respective function keys
I I 1 I
GDGDGDB0GDGDQ
(4) WRITE Key
Press the [WRITE] key to select an operation and also to confirm the
input data.
WRITE