Cal Command; Commands For Parameter Selection; Item Command - Okuma OSP-U100M Operation Manual

4203-E P-162
SECTION
1
DATA SETTING
3-1 -3. CAL Command
=C
ITEM
t
[EXTEND]
J
CAL SEARCH
ITEM
l
SET
ADD
FI
) (
F2
1 (
F3
1 [
F4
] (
F5
] [
F6
] [
F7
] (
F8
Press [F3] (CAL)
"C" is displayed.
An arithmetic operation is carried out between the data entered and the
current
value to form a command
serving as new data for setting.
The CAL command is effective by pressing function key [F3], providing a display of "C" on the 21st line on
the display screen.
Enter the data from the keyboard and press
the WRITE key, and the math operation is
executed between
the entered data
and the current
data. The result of math operation
is input
as the new
data.
3-2.
Commands for Parameter Selection
This group consists of
six
commands:
ITEM, SEARCH, AXIS CHANGE, CURSOR, PAGE and EXTEND
3-2-1.
ITEM Command
=IF
=IB
SEARCH
ITEM
t
ITEMi [EXTEND]
SET CAL ADD
CfD GD © © CED © dp
"IF' or "IB" is displayed.
/
\
/
Each
time
[F7]
(ITEMJ) is pressed,
the
screen display
switches to the
next
category.
©
Each time [F6] (ITEMT)
is
pressed, the screen
display switches to the
preceding category.
This command is intended to select an appropriate parameter from those belonging
to the
subcategories
in
the table given in Section
4, 2.
"DATA SETTING".
The ITEM command is carried
out
when function key [F6] or [F7] is
pressed. Each
time one of these keys
is pressed, the display screen
is switched over to the preceding or
next
subcategory items.
"IF' or "IB" is displayed on the 21st line on the display
screen and the screen display
is
switched over.