Nc Optional Parameter Spindle (Okuma Vac) - Okuma OSP-U100M Operation Manual

4203-E P-416
SECTION 3 DESCRIPTION OF PARAMETER AND SETTING PROCEDURE
10. NC Optional Parameter SPINDLE (OKUMA VAC)
This screen displays the
parameters to be used for the high-accuracy machining
function and the
synchronized tapping function, which are allocated
to
NC optional parameter (bit), NC optional parameter
(word) and NC optional
parameter
(long word).
When the following parameters are set, the corresponding NC optional
parameters are
set
accordingly.
Conversely, if NC optional parameters are
set,
the corresponding
parameters
shown below are
set
accordingly.
I
PARAMETER SET
T97/07/1
5
14: 10:00
SPI NDLE(0KUMA VAC)
*NC OPTIONAL PARAMETER*
NO.
I
180000
I
1 SPINDLE ORIENT ZERO OFFSET
2 ZERO OFFSET
(SYNC. TAP)
3 IN-POSITION CHECK VALUE (SYNC. TAP)
4 SPINDLE RATED VALUE
(SYNC. TAP)
5
NUMBER OF TORQUE OVER TIME(Nx0. 01sec)
6 TORQUE
MONITOR START REVO. RAT 10 (JO
7 TORQUE
MONITOR DELAY TIME (0.1 sec)
8 RETURN SPEED OVERRIDES)
(SYNC. TAP)
9 684, G74 CONTROL SELECT
I ON (0:
FL0AT/1
:
SYNC.
)
0
20
0
0
0
0
0
1
Y
X
z
ACT POSIT
(WORK)
-0.001 -0.001 -0.001
ITEM
i
[EXTEND]
ITEM
t
SEARCH SET
©©©©©©®@
(1) SPINDLE ORIENT ZERO OFFSET (NC optional parameter (long word) No. 19)
Set the offset data used in spindle orientation for the spindle controlled by high-accuracy VAC.
Setting unit: VAC command unit (1/1000 (deg) or
1/10000 (deg))
Setting range: 0 to 359999 (1/1
000 (deg))
O to
3599999 (1/10000 (deg))
Initial value:
0
(2) ZERO OFFSET (NC optional parameter (long word)
No. 15)
Set the machine zero for spindle orientation applied
to the operation which is called out by an E
command.
Setting unit: VAC command
unit
(1/1000 (deg)
or 1/10000 (deg))
Setting range: 0 to 359999 (1/1000 (deg))
0 to 3599999 (1/10000 (deg))
For normal spindle orientation commands (RS command), orientation operation
is controlled using
the origin of the encoder.