Manual Magazine Operation - Okuma OSP-U100M Operation Manual

4203-E P-64
SECTION
3
MANUAL OPERATION FUNCTIONS
MCM:
(1) Press the TOOL CHANGE
CYCLE button.
The indicating lamp above
the TOOL CHANGE CYCLE button
comes on indicating that a tool
change cycle can be carried out.
O
(2) Hold the tool in the spindle by hand or using a proper base and
press the TOOL UNCLAMP button for vertical or horizontal
spindle. The tool in the spindle can be removed. When the
TOOL UNCUWIP button is pressed, the indicating lamp above
the button comes on.
® -cCa) <j)
o o
(3) Set
a new tool
in the spindle and press the TOOL CLAMP
button for the spindle for which the tool is
to
be set. This turns
off the TOOL UNCLAMP and TOOL CHANGE CYCLE lamps
and the manual tool change cycle ends.
O O
: (1) When it is necessary to cancel the manual tool change cycle mode after pressing
the
TOOL CHANGE CYCLE button, simply press the TOOL CHANGE FINISH button on
the machine
operation panel.
(2) When changing tools manually, the tool number presently on the spindle and the active
tool number displayed on the ATC
operation panel will differ. Write the correct active tool
number on the *TOOL DATA SET
*
screen
to avoid having the tool returned to the swing
magazine
pot.
4-3. Manual Magazine Operation
Turn the MANUAL INT. switch on the MG MANUAL
operation panel ON to allow manual magazine
operation.
Switch Name
Function
MANUAL INT
-
ON
The automatic tool change cycle is interrupted immediately eve during
ATC operation when the MANUAL INT. switch is ON. The lamp above
the switch lights, indicating that manual magazine operations are
enabled. The lamp will not light up when manual magazine operation
creates
hazards and it is not allowed. After returning the MANUAL INT.
switch back
to
OFF from ON, the interrupted cycle will automatically
restart from the ATC operation point reached before turning the switch
to ON and will execute until up to the end of the cycle.
CONSTANT INDEX
-
ON Continuously rotates the magazine without stopping at each
pot.
INDEX START -
CW/CCW CW Rotates the magazine in a clockwise direction.
Rotates the magazine in a counterclockwise direction. CCW
INDEX STOP Pressing this button while the magazine is in continuous rotation stops
the magazine at the nearest pot position in the direction of rotation.
EMG. STOP Cuts operating power to the NC control box.
(Refer to Section
2, 3.
"Emergency Stop".)