Act Tool; Nxt Tool - Okuma OSP-U100M Operation Manual

4203-E P-58
SECTION
3
MANUAL OPERATION FUNCTIONS
(b) ACT TOOL
This indicates the tool number of the tool
set in the spindle.
[Supplement]
1 .
The maximum tool number is the same as the number of
tool offsets. (50 in
standard)
2.
In case the set tool number has already been assigned to another toolpot number,
an error occurs. Although a large-diameter tool (XX,
L)
can be
set, setting
of a
dummy tool (D) is impossible. In case the pot number has already been specified in
the SPCY POT column, and when a large-diameter tool is specified, the adjacent
toolpots should have no tool data or be assigned with dummy tool (D). Otherwise,
an
alarm
occurs.
Setting of a large-diameter tool (XX, L) is possible but the setting of a dummy tool
(D) is impossible.
In case a large-diameter tool is specified with pot
number entered in the SPCY
POT, an error will occur if no tool or a dummy tool (D) is not assigned with the pots
prior/next
to
the SPCY POT.
In case a large-diameter tool is specified with no
pot
number entered in the SPCY
POT data location, an error will occur if there are no three
empty pots arranged in
succession or no
two empty pots in succession next to the pot assigned with a
dummy tool (D).
3.
4.
5.
(c) NXT TOOL
This indicates the tool number
to be set in the spindie next. No data
is
entered for
the first
tool
returning cycle.
[Supplement]
1.
The maximum number is the same as the active tool.
2.
In case there
is a mismatch between the tool number specified and the toolpot
number, an error occurs.
3.
Setting of a large-diameter tool (,L) and dummy tool (D) is impossible.
4.
An error will occur when
pot
number is specified in the SPCY POT data location.