Program Branch; Optional Stop; Mirror Image - Okuma OSP-U100M Operation Manual

4203-E P-99
SECTION
5
AUTOMATIC MODE OPERATION
10.
Program Branch
When the PROGRAM BRANCH switch on the machine operation pane! is switched
ON,
the program
branch function is
turned on
and
the program branch commands in the program are executed.
r
PROGRAM
BRANCH
PROGRAM
BRANCH
2 1
Two PROGRAM BRANCH keys
are provided and each of them turns on/off
a
program branch command
respectively.
For details, refer
to
"SUBPROGRAM FUNCTIONS" in the Programming Manual.
11.
Optional Stop
When the OPTIONAL STOP switch on the machine operation panel
is
switched ON, the optional
stop
function is turned on and program execution is suspended at the block in which
M01 is specified. Pressing
the CYCLE START switch cancels the optional stop state and the program is restarted.
When the switch is off, M01 is neglected. In this case, the program
is executed continuously without being
stopped.
12.
Mirror Image
When the MIRROR IMAGE switch on the machine
operation
panel is switched ON,
and the mirror image
function is turned on for the corresponding axis.
For the axis for which the mirror image function is called,
the sign of the coordinate values is reversed.
Press a MIRROR IMAGE switch
while
holding the INTERLOCK RELEASE key.
MIRROI MIRROR
IMAGE
MIRROR
IMAGE
MIRROR
IMAGE IMA(
4
X Y Z
INTER
LOCK
RELEASE
In addition, there is a programmable mirror image (G62) function, having
the mutual relation described
below.
Mirror Image
by Switch
Mirror Image
by G Code
Switch of the Coordinate
Value Data Signs
OFF OFF Does
not
switch
OFF ON Switches
ON OFF Switches
ON ON Does not switch
The relation
is
established for each axis, independently.
For details of the programmable mirror image function, refer to "Programmable Mirror Image (G62)" in the
Programming Manual.