Deletion - Okuma OSP-U100M Operation Manual

4203-E P-226
SECTION
2 PROGRAM OPERATION
5-7. Deletion
(1) Program data in
a
specified range is deleted.
After specifying the number of lines
to
be deleted, press function key [F5] (DELETE). The specified
number of lines will be deleted including the edit line (»).
The edit pointer is placed
at
the first character of the block which follows the final line of the
deleted blocks.
(2)
(3) When the number of the specified lines
to be deleted is larger than the final block of the file, all
program data up
to the end
of the
file is deleted and the line right after the final line of the file
becomes the edit line. In this
case,
the message "file end" will appear.
After program data has been deleted, the message
"ÿRECORD
DELETE" appears on the
command line. Here, indicates
the number of
the deleted lines.
(4)
(5)
Lines following the deleted range will shift up.
Operation:
[F5] (DELETE)
-4
[WRITE]
Four lines preceding the edit line (edit line not included) are deleted.
[F5] (DELETE) [WRITE]
Only the edit line is deleted.